Hyundai Elantra: Preparation of tools and mesuring equipment - General Information - Hyundai Elantra HD 2006Ц2010 Service ManualHyundai Elantra: Preparation of tools and mesuring equipment

Be sure that all necessary tools and measuring equipment are available starting work.

SPECIAL TOOLS

Use special tools when they are required.

REMOVAL OF PARTS

REMOVAL OF PARTS

First find the cause of the problem and then determine whether removal or disassembly before starting the job.

DISASSEMBLY

DISASSEMBLY

If the disassembly procedure is complex, requiring many parts to be disassembled, all parts should be disassembled in a way that will not affect their performance or external appearance.
1.
Inspection of parts
Each part, when removed, should be carefully on suspected for malfunction, deformation, damage, and other problems.

2.
Arrangement of parts
All disassembled parts should be carefully arranged for effective reassembly.
Be sure to separate and correctly identify the parts to be replaced from those that will be used again.

3.
Cleaning parts for reuse
All parts to be used again should be carefully and thoroughly cleaned by an appropriate method.

PARTS

When replacing parts, use HYUNDAI genuine parts.

REPLACEMENT

REPLACEMENT

Standard values, such as torques and certain adjustments, must be strictly observed in the reassembly of all parts.
If removed, the following parts should always be replaced with new ones.
1.
Oil seals
2.
Gaskets
3.
O-rings
4.
Lock washers
5.
Cotter pins (split pins)
6.
Plastic nuts

Depending on their location.
7.
Sealant should be applied to gaskets.
8.
Oil should be applied to the moving components of parts.
9.
Specified oil or grease should be applied to the prescribed locations (oil seals, etc) before assembly.

ADJUSTMENT

Use gauges and testers to adjust correctly the parts to standard values correctly.