Hyundai Elantra: Installation - Side Impact Sensor (SIS). Repair procedures - SRSCM - Restraint - Hyundai Elantra MD 2010-2015 Service manualHyundai Elantra: Installation

Pressure Side Impact Sensor
1.
Install the new pressure side impact sensor with the screws (B) then connect the pressure side impact sensor connector (A).
Tightening torque :
2.5 ~ 3.5 N.m (0.25 ~ 0.36 kgf.m, 1.8 ~ 2.6 lb-ft)

•
Use the specified screws surely.
2.
Install the front door trim.
(Refer to the Body group - "Front door")
3.
Reconnect the battery negative cable.
4.
After installing the pressure side impact sensor, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
•
You must comply with the specified tightening torques with the tool specified because Pressure – Side Impact Sensors (P-SIS) may be broken or POP-NUT may be rotated.
•
Problems may be occurred in the durability of P-SIS or impact sensing performance may be depreciated if POP-NUT is rotated.
•
The door module must not be transformed because SRSCM judges a impact through the pressure sensor in the door module.
Side Impact Sensor
•
Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.
1.
Install the new side impact sensor with the bolt (A) then connect the side impact sensor connector (B).
Tightening torque:
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)

2.
Install the center pillar trim.
(Refer to the Body group - "Interior tirm")
3.
Install the door scuff trim.
(Refer to the Body group - "Interior tirm")
4.
Reconnect the battery negative cable.
5.
After installing the Side Impact Sensor, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.