Hyundai Elantra: Installation - Seat Belt Buckle Switch (BS). Repair procedures - SRSCM - Restraint - Hyundai Elantra MD 2010-2015 Service manualHyundai Elantra: Installation

Be sure to install the harness wires so they will not pinch or interfere with other parts.
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
3.
Install the seat belt buckle switch.

Tightening torque:
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~39.8 lb-ft)

4.
Install the front seat assembly.
(Refer to the Body group - "Front seat")
5.
Reconnect the battery negative cable.
6.
After installing the seat belt buckle switch, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator should be turned on for about six seconds and then go off.