Hyundai Elantra: Installation - Curtain Airbag (CAB) Module. Repair procedures - Airbag Module - Restraint - Hyundai Elantra MD 2010-2015 Service manualHyundai Elantra: Installation

1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes.
3.
Tighten the curtain airbag mounting bolts.

Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Never twist the airbag module during installation. If the airbag module is twisted, it may not operate as designed.
4.
Connect the curtain airbag connector.
5.
Install the roof trim.
(Refer to the Body group- "Interior")
6.
Reconnect the battery negative cable.
7.
After installing the curtain airbag (CAB), confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.